Skip to content

Node Mass Flow Variables

The node mass flow variables merit a little more discussion. Six mass flow variables are defined at each node. They are: MassFlowRate, MassFlowRateMin, MassFlowRateMax, MassFlowRateMinAvail, MassFlowRateMaxAvail and MassFlowRateRequest. These variables hold loop mass flow rate information according to the following definitions.

  • MassFlowRate -- this node variable holds the simulation mass flow rate for the current timestep. The remaining four variables serve as limits to MassFlowRate.

  • MassFlowRateMax, MassFlowRateMin -- These node variables hold the maximum possible and the minimum allowable flow rates for a particular component. As such, they represent the "hardware limit" on the flow rate for the component.

  • MassFlowRateMaxAvail, MassFlowRateMinAvail -- these node variables represent the loop maximum and minimum flow rate for the current configuration of the loop on which the component resides.

  • MassFlowRateRequest  --  this node variable applies only to plant and holds the desired mass flow rate for the current timestep.  This stores a record of what flow was desired.